@EricM_Inovelli Bypass came in today. Tried both the incandescent and the an led and got the same behavior for both bulbs. When I turn on the circuit the switch powers up, the light bulb flashes on for a split second then the switch reboots. Can someone verify i wired the bypass correctly? From what I understand I connect the bypass between the hot and neutral on either side of the light. LED is a GE relax. https://www.lowes.com/pd/GE-Relax-60-Watt-EQ-A19-Warm-White-Dimmable-LED-Light-Bulb-4-Pack/1000444891
Update for the night. @Bry verified white is in line and black is load.
Updated target 0 to 1.48 from 1.47 fw. Controller software reads back 1.48 fw on device but ST still says 1.47 on summary page. I had to reset non-neutral and load only config options via ST web interface. Switch is behaving better (with incandescent bulb and no bypass) but still reboots after cycling on and off several times. I tried all my bulbs again with the bypass and they all boot loop indefinitely. I’m at a loss what do do with the bypass.
Just for fun I connected a neutral and the switch worked without any issues. So it’s something with the non-neutral configuration.
@EricM_Inovelli any suggestions what to try next? I read through a bunch of non-neutral config posts and someone suggested a second bypass? I’m also going to order one of the cree light bulbs on the confirmed working list.
Are you serious? The switch no longer requires disable local control and the switch on 99% all the time and no LED bar control?
I had no idea, but this is literally the largest request I still had outstanding. ALL of my 31-SN’s that are controlling smart bulbs have local control disabled and show the full LED bar always (even when lights are off).
So smart bulb mode essentially disconnects the dimmer from controlling the load, but the switch operates normally otherwise?
Edit: I’m back because now ST won’t let me change the “Disable Local Control” from Yes to No within the new app. I did find some blanked lines in the DTH:
@EricM_Inovelli any ideas? I was able to modify the parameter in ST IDE so good to test, but kind of weird the app isn’t letting me change (when I select the parameter it says No or Yes, I pick No and it stays Yes in the setting???).
My lzw31-sn doesn’t like to take settings from the ST app. I’ve been using the web interface. I’m using the 9/21 device handler. I have mine setup to pull from GH so it shouldn’t be a copy paste error.
@EricM_Inovelli@Bry Yahtzee! I tried wiring up a second bulb and messing with settings since everyone went to bed early tonight. If I turn off smart bulb mode it works perfectly! With a single bulb I need the bypass but with a second I don’t need it. Parameters from ST listed below.
