Home Assistant - Config Read Only

Digital Lounge General Discussion
,
1

Hello all

I just got my first switch installed and have jumped through the 2134 hoops to get it to show up in my Home Assistant. When I go to the config tab it tell me that “This panel is currently read only”…

Is this real. Am I not able to make changes to all the settings from the HA UI? I initally had the switch working on my SmartThings hub and was able to set what i needed.

My setup is a little different…

Running HA 2021.4.3 in a container on my QNAP
Running MQTT in a container on QNAP
Yep, running openzw in a container on QNAP

Advice here appreciated.

2

Use the OpenZwave admin tool on a PC on your network.

3

Thanks… Some settings are still grayed out but this is a step closer.

4

Welp. Guess I jumped in too quick. Changed over to zwave js and YES… Can now make changes in HA.

5

Use ZwaveJSMQTT and can make changes within it too.

What was greyed out in the openZwave admin tool? I could access everything when I was using it.

6

Any of the settings that were in drop downs were disabled and I could not make changes. With zwjs I can now make all these changes in home assistant which was my goal.