Just got my first combo switch (of 6) installed and going through the driver to make my adjustments. Is there not the ability to set custom LED colors or am I just overlooking it? All of the rest of my Inovelli switches throughout the house are set at a custom color, so I’d like to at least set the light side of the switch to that same custom color (for consistency purposes).
I could always just make the rest of my switches basic green, but I rather like my toned down green color =)
I’d be great to enter a custom color code rather than choosing from the drop down. This would be nice for the switches/dimmers/fan&Light.
This site is great at choosing your exact color.
Anyone ever figure out how to do this? I was trying to set all my switches to orange like the advertising and the basic colors don’t look that good
Yes I figured it out. Create the child LED device for each switch. Then from within that child LED, you can configure a custom LED color.
I know this is an old thread, but my issue is relevant. I am trying to use the settings you referenced, but every time I change the “Light Indicator Color when On” (and for the fan indicator), the settings don’t stick. When I click “Save Preferences” the colors I set remain (but the LEDs don’t change color). If I refresh the page or if I click “Save Device” the value reverts I’m sure I’m doing something wrong, but not sure what. I’d appreciate any advice here. Thanks!
Hubitat firmware: 2.2.7.126
LZW36 firmware: 1.34
Update: I upgraded the switch firmware to v1.36 and the issue with the color choices remains…
Update2: disregard this post, sorry. I switched to the Inovelli custom driver, from the Hubitat built-in driver, and now I can set the LED color as expected.
